Peel & Stick Sika Sarnafil’s new Peel & Stick membrane provides the building owner with the benefits of an adhered roofing system without the concern of disrupting building operation during installation. Peel & Stick has no odors or volatile organic compounds to bother building occupants and disrupt building operations.  It's perfect for hospitals, schools or any building where odors and VOC emissions are a concern.  And, because the adhesive is applied at the factory, you are assured of consistent coverage.  Peel & Stick saves time and improves rooftop productivity allowing the roof to be completed and watertight sooner. Click here to obtain specifications and details for the peel & stick system. View a video about Peel & Stick Click on the link below that corresponds best to your connection speed: Peel & Stick - 56k Peel & Stick - 100k Peel & Stick - 300k After the usual preparation of the roof deck, installation of the 6.5 ft. wide membrane requires just four simple steps: Unroll the Peel & Stick membrane; Cut to fit, laying it in place, and pulling off the release liner; Smooth it out with a broom; and Press it down with a roller. Completing a job in half the time required by a traditional, adhered roof is a typical Peel & Stick benefit. Key: 1: Structural Deck 2: Vapor Retarder 3: Insulation 4: Insulation Fastener Sika Sarnafil’s Peel & Stick membrane is manufactured using the same time proven formulation that has been protecting roofs for over 40 years.  That means you can have confidence that Sika Sarnafil’s Peel & Stick membrane will continue to perform for years to come.       As it is an EnergySmart Roof® membrane it's highly reflective surface reduces solar heating of the roof and building envelope, reducing building cooling costs and reducing the urban heat island effect that is a contributor to smog formation. © 2006 Sika Sarnafil | 100 Dan Road | Canton, MA 02021 | 800-451-2504 | webmaster.sarnafil@us.sika.com Legal Disclaimer